Golden Gate Bridge
Plan your website and create the next important tasks for get your project rolling
Golden Gate Bridge
by Jason Lee
1. Type Of Structure
1.1. the golden gate bridge is a Frame structure
1.2. parts are solid
2. External Force
2.1. wind
2.1.1. mangitude
2.1.1.1. the wind will blow hard on to the bridge
2.1.2. plane of application
2.1.2.1. the wind will blow in a 90 degree angle
2.1.3. point of application
2.1.3.1. the wind will blow all over the bridge
2.1.4. direction
2.1.4.1. the wind will push the bridge
3. Loads
3.1. the golden gate bridge is a dead load because it could support it's self
3.2. when cars go over the bridge it will be a dynamic load then because of cars and trucks etc zooming on the bridge
4. Made By Jason, Maxwell, and Sherman
5. puForm And Function
5.1. travels people from Sanfransisco Mainland to Marin Contry
5.2. large suspension bridge
5.2.1. lots of wires and poles to keep it standing and supported
5.3. this bridge's purpose is to transport people from one end of San Francisco to Marin country. they had used ferries but people complained that they wanted a bridge than ferry services. they first built this large unstable bridge that fell under the sea. a few years later they had to think of a new plan so they came up with golden gate bridge
6. Internal Force
6.1. compresion
6.1.1. cars pushing on bridge while ground pushing
6.2. tension, the wires are pulling up the posts and its pulling the floor of the bridge
6.2.1. bridge pulling while stands pulling
6.3. compression 2
6.3.1. wind blowing on bridge